Session 6.4: User-Defined Diagnostic Analysis

Session 6.4 Outline

• 6.4.1: Create a User-defined Sensor Analysis
• 6.4.2: Export a Sensor Set from an Automated Analysis
• 6.4.3: Sensor Set Details Report

Discussion 6.4.1: Create a User-Defined Analysis

There are two methods to create a user-defined analysis:

Method 1

1. Open the Overview/Management page
2. Select the create/add icon to open the Create a Diagnostic Analysis dialog
3. Select the check box for the Vehicle system level of indenture
4. Set the Type of Diagnostic Analysis to User-defined
5. Select proceed (Next) to continue to the final dialog page to enter the Analysis name, Description & Propagation type

Note: This method follows the same process as the Automated diagnostic analysis.

Discussion 6.4.2: Export a Sensor Set from an Automated Analysis

Method 2: Export a sensor set from Automated diagnostic Analysis

• Allows user to select a candidate sensor set and export it into its own analysis
• This analysis only focuses on the exported sensor set — no additional sets can be created
• Exported sensor set can be compared to legacy sensor set
• Additional information can be used to populate sensor parameters

Exercise 6.4.2: Export a Sensor Set from an Automated Analysis

Using method 2: Export a sensor set from Automated diagnostic Analysis by:

1. Selecting the Sensor Set Analysis page
2. Select the starred analysis set in the table
3. Select the export icon to export the analysis
4. Verify that a new analysis has been created
   • Check tabs on left for Exported Group

Discussion 6.4.3: Sensor Set Details Report

The Sensor Set Details report consists of several sections:

• Sensor Set Group provides an overview of the Sensor Analysis details
• Sensor Sets Overview table shows sensor data for each analysis set
• Test Points/Sensors table shows sensor data for the legacy sensor set
• Diagnostic Sets table lists diagnostic data for each analysis set
• Ambiguity Groups table lists each ambiguity group and corresponding causes & criticality

Exercise 6.4.3: Sensor Set Details Report

To generate a Sensor Set Details report:

1. Select Reports > Report Wizard from the main menu
2. Select Sensor Set Details Report then Next
3. Set the Diagnostic Analysis to Exported Group - Diagnostic Analysis 1
4. Select both the Legacy Sensor Set and Analysis 1 — Set 1
5. Select Next to go through report formatting options
6. Select Generate to generate the report

Session 6.4 Summary

• 6.4.1: Create a User-defined Sensor Analysis
• 6.4.2: Export a Sensor Set from an Automated Analysis
• 6.4.3: Sensor Set Details Report