Report Filtering

Report Filters can be used to eliminate results where specified Failure Concepts form

part of the report.

These filters can be applied by using the Report Filtering preferences, filtering may

be achieved on an individual basis (e.g cause: Design - Blocked Opening) or according

to a concept type (Mechanical, Electrical and Plastics). Note: Report Filtering

will directly affect all reports generated in MADE.

Editing Report Filters

1. Select Reports → Report Filtering
2. Check all failure concepts to be filtered out

The "Type Filters" can be used to help filter out unnecessary failure

concepts that do not relate to the type of model being reported when searching for

failure concepts to filter out.

[Image: ReportFilters.png]