PHM Reports

Test Point Report

A Test Point Report provides a summary of a selected component or

subsystem in a system. This report shows the Probability of Detection (POD) of all flow

properties and symptoms for a specified item, as well as sensor details and parameters.

To create a TP report:

1. Select Reports → Report Wizard in the main menu
2. Select Test Point then select Next
3. Select the component or subsystem
4. Select Finish to generate the report

[Image: CTP.gif]

Sensor Set Details Report

The sensor set details report summarises the details in a sensor analysis, based on

the sensor sets selected. The report contains an overview of the sensor set group, each

sensor set details, ambiguity groups and diagnostic sets. To generate a Sensor Set

Details report:

1. Open the Report Wizard
2. Select Sensor Set Details then select Next
3. Select the Diagnostic Analysis from the drop-down menu
4. Select the Sensor Sets to include in the report
5. Go through page setup or select Finish to generate the report

[Image: SensorSetReport.gif]